你好,欢迎来到经管之家 [登录] [注册]

设为首页 | 经管之家首页 | 收藏本站

基于GSM的无线通信系统_自动化专业论文范文

发布时间:2015-01-18 来源:人大经济论坛
自动化专业论文范文 目 录 摘 要I AbstractII 1 前 言1 1.1 课题背景1 1.2 GSM概况2 1.3 论文主要研究的内容与意义2 2 GSM系统及其技术3 2.1 GSM系统的特点3 2.2 GSM系统的体系结构4 2.3 GSM的信道6 3 无线通信系统的硬件设计7 3.1 系统总体结构7 3.2 GSM无线通信模块的设计8 3.2.1 西门子TC35i的性能特点8 3.2.2 基于TC35i的无线通信电路设计9 3.3无线通信系统电源电路的设计11 3.4无线终端报警系统的设计12 4 无线通信系统的软件设计14 4.1 GSM软件协议14 4.1.1 AT指令的简介与使用14 4.1.2 PDU短消息编码15 4.2 通信系统软件流程设计17 4.3 软件设计思想18 5 无线通信系统调试19 5.1 TC35i与电脑调试19 5.2 TC35i与串口调试工具调试。20 5.3 单片机与TC35i调试21 5.4 调试中的问题22 6 总 结23 致 谢24 参考文献25 附录1 系统硬件原理图26 附录2 系统软件程序30 摘 要 本文主要叙述了研究本设计的目的、意义以及本系统可能使用的场合。介绍了GSM网络体系结构及GSM短消息的特点。讨论了系统使用的GSM模块的特点与性能,对其外围电路进行设计。分析了PDU短消息以及控制短消息收发的AT命令的应用。对主控端系统的功能进行了设计和实现,完成了整个系统的结构设计和功能实现,进行了程序编写与电路设计。最后介绍了该系统的应用前景与推广价值。 本设计是基于GSM模块与单片机系统以及报警电路的无线通信系统,由GSM模块、单片机、报警电路、天线、电源模块构成。该系统研究了如何把GSM模块与单片机系统及报警电路整合起来,将短消息与报警结合起来从而实现了无线通信与报警。其工作流程为,开关打开以后系统会发送一条短信到目标手机,然后发光二极管点亮,继电器动作。这样就实现了报警与无线通信。该系统稍作改动即可广泛应用于防盗与工业控制等方面。 关键词: GSM,单片机,短消息,报警 Abstract This paper describes the purpose and Significance of studying the design and The possible use of the occasion of this system. Introduce GSM Network Architecture and the characteristics of GSM short message. Discussed the characteristics and performance of the GSM module what the system used,design the Peripheral circuits of system. Analysis the PDU short message code and how use the client application of the AT command to control send short messages.Design and implement the function of Control client, Completed the structural design and function to achieve of the whole system. Carried out the programming and circuit design.Finally, Introduce the the value of promote and Application prospects. This design is based on the wireless communicate system of GSM module single-chip system and annunciator circuit,GSM module single-chip annunciator circuit antenna power module make up of the wireless communicate system.This sytem study how to link GSM module single-chip system and annunciator circuit,use short message and alarm to achivev wireless communicate and alarm.The step of the system is that,if the switch close,system will send a short message to the objective mobilephone,then the LED light, the relay closed,in this way the system complete alarm and wirelsee communicate.if the system make some changes,the system will applcate comprehensively in insurance aqainst theft and Industrial Control Etc. Keywords: GSM, single-chip, short message, alarm
经管之家“学道会”小程序
  • 扫码加入“考研学习笔记群”
推荐阅读
经济学相关文章
标签云
经管之家精彩文章推荐