[求助]不好意思，还是mlogit的问题

是 否 +2 论坛币

k人 参与回答

经管之家送您一份

应届毕业生专属福利!

求职就业群

赵安豆老师微信：zhaoandou666

经管之家联合CDA

送您一个全额奖学金名额~ !

立即领取

感谢您参与论坛问题回答

经管之家送您两个论坛币！

+2 论坛币

各位高手：

我在此学到很多知识，还是有些不懂

现在已经学会mlogit的命令，但是无法指定对照组

书上说用basecategory（#）但是程序上出现错误

例如：

mlogit q  old edu oj oj2 ft ft2,basecategory(0)

option basecategory() not allowed
r(198);

怎么改正？？

在线等

急呀！！！

版主呀

高手呀

扫码加我 拉你入群

请注明：姓名-公司-职位

以便审核进群资格，未注明则拒绝

分享0 收藏0 回帖

关键词：mlogit logit 不好意思 Log Category mlogit

    Setup
        . webuse sysdsn3

    Fit multinomial logistic regression model
        . mlogit insure age male nonwhite site2 site3

    Same as above, but use 2 as the base outcome
        . mlogit insure age male nonwhite site2 site3, base(2)

    Replay, reporting relative-risk ratios
        . mlogit, rrr

命令的查stata自带的帮助

stata10的一些选项改变了

但是基本的是不变的，所以你的查帮助

For answering your question, I found the help resources of Stata.com in http://www.stata.com/help.cgi?mlogit.

In that webpage, you can find the correct command of basecategory such as "baseoutcome(#), base(#) or b(#)", not "basecategory(#)".

However you didn't make a categical variable before using mlogit, I think.

Because you said "... 但是无法指定对照组."

In the mgolit command of Stata,the default is to choose the most frequent outcome.

For example, if "q" of your dependent variable is composed of 5 high income groups(=1), 4 middle income group(=2) and 10 low income group(=3),the base outcome is automatically 3, that is low income group, and also you just do mlogit without base(#).

When you want to change the base outcome or group for additional analysis, you must use the command of bsae(#).

So you must check whether your dependent variable "q" is correct and then do mlogit.

I hope you enjoy Stata's wonderful world.

[此贴子已经被作者于2008-9-1 22:13:41编辑过]

eblog  金币 +2  金钱 +20  魅力 +10  经验 +10  奖励 2008-9-2 9:29:52

如果选择缺省的话，stata会自动默认对照组为1，你的”0“似乎不能作为对照组。仅供参考。

请问一下，您这个问题当时怎么解决的啊，谢谢啦